About
Accounts
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.
Click here to check if anything new just came in.
February 08 2011
Cube Gears
Cube Gears. Designed in OpenSCAD by emmett (http://www.thingiverse.com/thing:6073).
Printed on a Thing-O-matic with a stepper extruder.
Cube Gears. Designed in OpenSCAD by emmett (http://www.thingiverse.com/thing:6073).
Printed on a Thing-O-matic with a stepper extruder.
May 09 2010
January 31 2010
Bus Pirate V2 Enclosure
This enclosure was modeled using OpenSCAD. The model is partially parametrized, meaning you can adapt the parameters given at the start of the file and an enclosure will be generated to fit your inner volume, holes, material thickness etc.
See www.thingiverse.com/thing:1716 for model source code.
This enclosure was modeled using OpenSCAD. The model is partially parametrized, meaning you can adapt the parameters given at the start of the file and an enclosure will be generated to fit your inner volume, holes, material thickness etc.
See www.thingiverse.com/thing:1716 for model source code.
Reposted by
clifford
clifford
Older posts are this way
If this message doesn't go away, click anywhere on the page to continue loading posts.
Could not load more posts
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Just a second, loading more posts...
You've reached the end.
