Tumblelog by Soup.io
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.

February 08 2011

kintel
19:16
9783_56f7_500
→ www.flickr.com
Cube Gears
Cube Gears. Designed in OpenSCAD by emmett (http://www.thingiverse.com/thing:6073).

Printed on a Thing-O-matic with a stepper extruder.
Tags: thingiverse makerbot thingomatic openscad

January 28 2011

kintel
15:25
7067_afc1_500
→ www.flickr.com
Catarina's Spur Gears
Printed on a Thing-O-matic with a Stepstruder MK6 prototype.

www.thingiverse.com/thing:1336
Tags: thingiverse makerbot thingomatic

January 25 2011

kintel
15:19
0788_3032_500
→ www.flickr.com
Hyperboloid
George Hart's hyperboloid.
Printed on a Thing-o-matic with a stepper extruder and the reversal plugin to Skeingforge with default parameters.
This has not been cleaned. Printed for reference.
Tags: skeinforge makerbot thingomatic

January 13 2011

kintel
14:36
4345_6e4a_500
→ www.flickr.com
Plastruder Mk5 alternative resistor mount
Hot soldering the wires to the resistors was messy. I think this alternative approach is a better solution. Use M2 screws and nuts, and a star washer to get a better grip on the wire.
Tags: metalab makerbot thingomatic
Older posts are this way If this message doesn't go away, click anywhere on the page to continue loading posts.
Could not load more posts
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Just a second, loading more posts...
You've reached the end.